Learning Articles

That’s a good question that requires us to dig deeper for a full evaluation.  In order to fully address the question, we need to break it down a bit.  It’s good to note that Brentwood makes glued fill packs as… Read More

It’s a valid question and one that Brentwood is quite capable of answering as we produce both Polyvinyl Chloride and Polypropylene film fills.  For a much more in-depth look at the chemistry differences between these two polymers you can reference… Read More

What’s the difference between Brentwood XF75 cooling tower fill supports and using repurposed PVC shipping pallets? That’s a good question and one we get asked frequently by owners.  While cutting down plastic shipping pallets and using them as fill supports for… Read More

We were recently asked about PM10 emissions for a cooling tower.  This relatively simple question is in fact quite complex. The short answer is that the PM10 emission rate depends on several factors. Nozzle type and pressure are a factor,… Read More

Grey water is being considered more and more for cooling tower water, but what about untreated grey water with high concentrations of ammonia? We know how to handle the TSS, but what about ammonia in cooling water? Does ammonia do… Read More

The purpose of FM Approvals Standard for Cooling Towers, Class FM4930, is to state the requirements for cooling towers that do not need automatic sprinkler protection. When going through the Approval process one of the key steps is to build… Read More

Oil prices have dropped a lot over the past year, so why isn’t there a corresponding decrease in cooling tower fill price? The answer is that raw material costs have not decreased by 50%. Gas prices at the pump, maybe.… Read More

Brentwood introduced the AccuShield antimicrobial technology in 2008, to reduce weight gain associated with fouling and improve the performance of cooling tower fills and drift eliminators. Here’s a quick video to introduce you to the technology: The video discusses that… Read More

Brentwood developed its Mechanical Assembly (MA) Technology in the year 2000 as a solution to the industry-plaguing process of gluing plastic sheets together to create fill and drift eliminator packs. The gluing process was time consuming, costly, and released harmful… Read More

What is a cooling tower? A cooling tower is a heat rejection device that utilizes the evaporative cooling process to transfer waste heat to the atmosphere. Waste heat enters the cooling tower as warm water and is pumped to the water… Read More