Category: Cooling Tower
Back to All Learning ArticlesThat’s a good question that requires us to dig deeper for a full evaluation. In order to fully address the question, we need to break it down a bit. It’s good to note that Brentwood makes glued fill packs as…
Read MoreIt’s a valid question and one that Brentwood is quite capable of answering as we produce both Polyvinyl Chloride and Polypropylene film fills. For a much more in-depth look at the chemistry differences between these two polymers you can reference…
Read MoreWhat’s the difference between Brentwood XF75 cooling tower fill supports and using repurposed PVC shipping pallets? That’s a good question and one we get asked frequently by owners. While cutting down plastic shipping pallets and using them as fill supports for…
Read MoreWe were recently asked about PM10 emissions for a cooling tower. This relatively simple question is in fact quite complex. The short answer is that the PM10 emission rate depends on several factors. Nozzle type and pressure are a factor,…
Read More